HS used to have an aluminum pipe inside the pistol grip to keep it from snapping in 2 there. Not sure if they still do and if so how far into the butt it goes.
HS used to have an aluminum pipe inside the pistol grip to keep it from snapping in 2 there. Not sure if they still do and if so how far into the butt it goes.
That stinks,
As much as HS precision thinks their stocks are worth,
A fella would at least think they would give decent customer service and answer a straight forward question about installing a cheek riser on one of their stocks.
Though I am not very likely to run out and buy one of their stocks because of their cost vs the competition, Stuff like this lets me know where to spend my money should I need a higher end stock in the future.
Did you tell em you painted it? They'll probably tell you that voids the warranty too.
A good wife and a steady job has ruined many a great hunter.
Someone here recommended the Bradley Adjustable Cheek Rest so I picked one up for $110, works great and it stays on well. I was going to go the drill way and get a kydex riser but after fubaring the forearm while drilling to put on a rail for the bipod, I didn't want to go through the same thing twice. When I drilled under the forearm, there was this powder stuff and it felt like it was going to fall apart so I jammed the screw in there and left it. I have to go back and fix that because I like this stock a lot.
Bookmarks