I have watched a few videos in my search to reload rifle cartridges better. I have not been at it long. I am using a Redding body die to bump the shoulder back and a Lee collet die to size the neck. I realize there are other ways to do this as well as just full size every time. However, this is what I want to try.
So, after sizing the brass and to check that the brass chambers easily I have removed my firing pin. The bolt doesn't seem to move any other way than what it feels to close the bolt with the firing pin in. Am I supposed to remove the ejector as well? I understand that the bolt should almost fall into place, but it does not. Any advice?