Hello!

My 10 FCP extracts spent cases only if I push the bolt handle up all the way and give a little tension to it while pulling the bolt back.
If I pull the bolt out only a little amount and I shake the bolt handle a little bit the case and the extractor loose their connection and you
have to get out the case with the fingers. So I'm wondering if it is normal that the bolt is very loose in the action or if I can adjust this by hand.
I read a lot about replacing the extractor with a 3rd party product (e.g. from SSS) but I don't think the extractor would solve the problem
because of the loose bolt in the action.

Thank your for your replies,

regards

Please excuse my poor English but I hope I could explain what I mean.