Reply With QuoteOf course you can
I noticed when I bought my flcp-sr that there is a plug or outline so to speak on the right side of the stock where the bolt handle would rest. This got me thinking I really like the b&c stocks for the price compared to say a manner, mcm or hs so could I buy a b&c stock and just use a router to cut out a bolt handle notch for my left hand action?
Sent from my VS995 using Tapatalk
Of course you can
I'm a firm believer in the theory that if it bleeds, I can kill it.
Sweet
Sent from my VS995 using Tapatalk
And you can fill in the other side.
The Dunning-Kruger effect is alive and well.
You can, but often times it will leave the stock weak in the wrist area which will likely lead to it cracking in that area down the road.
Even with an aluminum skeleton?
Sent from my VS995 using Tapatalk
Even more so with an aluminum skeleton.
"As long as there's lead in the air....there's still hope.."
What if I fill in the right side
Sent from my VS995 using Tapatalk
The fill adds no strength. Once the primary cut is made it compromises the integrity of the stock. It make no difference if it's wood, fiberglass, or a combination of such with an aluminum block, it is the smallest cross section of the stock and takes all the stress.
"As long as there's lead in the air....there's still hope.."
Posting Permissions
Bookmarks