gone
Anyone make a single shot ramp for their axis? I know what is available commercially, looking for diy ideas.
thanks, Brian
gone
Last edited by mag410; 03-03-2017 at 10:50 PM. Reason: Spelling
Very ingenious! The pics are great, I'm a "visual" learner, pics are easier for me to understand than words/written instruction so this helps me a lot. What makes it even better is I already have some 06 cases with the long necks, ran them through a 308 die to make 308 cases but realized it is a lot easier to just get 308 cases. What did you use to make the white ramp, some type of epoxy put into a mould?
thank you for sharing this, Brian
gone
Why not get a second magazine and carve a plastic or wood filler? Shape the top with epoxy putty or something similar. Shoot single shot. Change the mag and shoot repeater.
The Dunning-Kruger effect is alive and well.
Can anyone tell me where I can get the poly sled single shot.
Have tried sss but when I use the E-mail I get a message that
say's the address does not exist.
Thanks
Bill
I have a Sharp Shooter Supply loading ramp for my .223 Axis, works great. The contact information I have is www.sharpshootersupply.com
Magilla26, PM sent.
Thanks
Bill
Sorry for the late reply; haven't been here for a while. Check out my post here:
http://www.savageshooters.com/showth...-single-rounds
Bookmarks