Reply With QuoteSet the tab in the slot (near the trigger).....place a flat head screwdriver on the other tab and tap the screw driver and it should pop right in (I use a rubber hammer). Put the screw driver at about a 30* angle to the action.
How does onwe go about putting the magazine wel back on action? Took it off when i bedded action and am having one heck of a time getting it back in place?
Model 12 btv .204 nikon monarch 4-16x50<br />Model 110La 243ai 26"brux 1:8 twist sss comp trigger leupold vx3 4.5-14x40 tack driver!!
Set the tab in the slot (near the trigger).....place a flat head screwdriver on the other tab and tap the screw driver and it should pop right in (I use a rubber hammer). Put the screw driver at about a 30* angle to the action.
Thanks ill give it a try. :)
Model 12 btv .204 nikon monarch 4-16x50<br />Model 110La 243ai 26"brux 1:8 twist sss comp trigger leupold vx3 4.5-14x40 tack driver!!
Check you receiver slots -- front slot is just sloted into forward portion of receiver while the rear slot has a bevel on outside edge of receiver. Insert the mag into the front slot then rotate the rear end down onto the bevel portion of the receiver above the slot. Bump the edge with heal of your hand, piece of wood, handle of a screw driver or rubber mallet. Doesn't take much to pop the tab into the rear slot using the bevel.
Posting Permissions
Bookmarks