Reply With QuoteMcmasterCarr is one place. When I am checking to see if my action screws are the right length I take the bare stock and insert the screws holding them seated I look at the screws from the inlet side.
I got a new McMillan stock for my 110 and I am curious if I need longer bolts to bolt the action to the stock? Both bolts will go through and thread in a little ways but it doesn't seem to be but a couple turns and I'm out of bolt. If I do need longer ones where is a good place to get them?
McmasterCarr is one place. When I am checking to see if my action screws are the right length I take the bare stock and insert the screws holding them seated I look at the screws from the inlet side.
The Dunning-Kruger effect is alive and well.
I got a packet of button hex heads at ebay. Had to trim them down cause the button head didn't fit the trigger guard, took care of it with emory cloth and a drill until they did. Cut them to length with a dremel.
Thread pitch 1/4-28
Posting Permissions
The sole purpose of this site is to provide an online community for those who wish to interact with other Savage firearm enthusiasts.
The information and opinions expressed within this site are those of its contributors, and in no way should be viewed as the opinions or recommendations of Savage Arms.
This site utilizes affiliate programs to generate revenue and as such purchasing a product reached by clicking on a link on this site may earn us a small commission on that sale.
Bookmarks