you could use your full length sizer and just do a partial resize, that will bump the shoulders back a little.
hey guys i want to bump my shoulders back but can't find bump dies. does anyone make them for the 338-06?
"And you shall know the truth, and the truth shall make you free.” John 8:32 (New King James Version)
you could use your full length sizer and just do a partial resize, that will bump the shoulders back a little.
you can do a partial neck size like that but when you back off on the die you move away from the shoulder
"And you shall know the truth, and the truth shall make you free.” John 8:32 (New King James Version)
keep screwing the die in more
Screw the die in a bit at a time until you have moved the shoulder the desirewd amount.
I have actually moved material from the bottom of the sizing die to get the desired effect on a wildcat I was working on.
Neal
358Hammer since it is based on the 06 do you think i could get by with a neck sizing bushing bump die for the 30-06 and just use larger bushings for the 338 neck size? there is according to my book 1/2 degree difference in shoulder angle. I really didn't want to size the whole case if i didn't have to.
"And you shall know the truth, and the truth shall make you free.” John 8:32 (New King James Version)
Bookmarks