Interesting. The top two parts in this diagram represent the inverse of the only two inlets I am aware of. The one in the middle will fit the top inlet. The one on the top would have to be modified to look like the middle one in order to fit. Also the trigger guard hole boss area(on the bottom metal) is thicker and may need to have a 1/4" screw washer placed underneath to bring it out so the mag does not drag on the magazine. If you look closer you can see the differences between the two.
Wait for others to chime in as it has been a while since I mixed and matched that kind of stuff. The point is a mildly talented craftsman/DIYer can probably make it work and it will look like it is factory. Then there is the high probability you will bolt it right in. I hope I did not confuse the subject. Good luck.
Bookmarks