Starting load suggestion for 300wm and 212 eldx

[Mthomas90]

I'm looking for starting load suggestions for my 300 wm and 212 eldx.
I am planning on using h1000 and maybe r26 if I can find some.
I have lots of other powders, so open to other suggestions.

Specs:
26" McGowan 10 twist
Nosler brass
Fed or cci mag primers

Thanks,
Michael

Sent from my SM-G930V using Tapatalk

[Londerko]

My load is 76grs of H1000
start at 73-74
i had best luck with a Fed215 primer

[Robinhood]

My load is 76grs of H1000
start at 73-74
i had best luck with a Fed215 primer

This or
69.5-70.5 H4831
Same primer

[darkker]

http://www.hodgdonreloading.com/

[Zero333]

I totally agree with Robinhood, 2 posts above.

Best accuracy I got was from H-4831 at 69.5gr, 3.470" coal. Federal brass, 2,724 fps agv. from a 24" stick, 210M sparkplug.

I tested 215M and 210M primers and velocity was the same (3 or 4 fps extra with 215M), Point of impact was the same, and accuracy was the same. So I use 210M since I have much more of them than 215M's.

Also tried H-1000 but accuracy wasn't there. If I remember correctly, 75.5g to 76.5gr was best with H-1000