Not quite following there list of needed parts for the conversion from a plastic to wood stock. Other than the wood stock the only other item needed were the action screws. Trigger guard could have been used from the plastic stock as I've done that on several guns until funds were available to up grade. Box magazine, follower with spring and retaining clip should be the same whether wood or plastic stock.
Believe I would use the old parts from your original set up. Assemble them in the wood stock then try chambering a round. If problem persists go completely back to the original configuration. Change one part at a time until it fails too feed properly. Last part changed is the problem more than likely.
Bookmarks