520 parts.

[Plain old Dave]

Lifter spring, the early V-type

Slide lock release spring

Rear trigger guard screw

Action bar and pump handle. Or just the bar if they can readily be interchanged.

Cosmetics aren't important, as the gun is rough cosmetically.

Sent from my SM-J700T using Tapatalk

[OkiMarine]

Dave,

I like these guys for the lifter springs: http://www.ebay.com/itm/Savage-Steve...-/141383836803

and Numrich https://www.gunpartscorp.com/Manufac.../520-41348.htm for everything else.

I've seen action bars for sale on ebay and Gun Broker, they have to be riveted to the pump handle. You can unscrew the front metal cap to remove the wood and inspect the connection on yours. That's where you will find stress cracking.

[Plain old Dave]

I think the action bar is good, no flexing, and the internal parts don't show the wear you'd expect from a well-used gun. Stored poorly, used very little .

Sent from my SM-J700T using Tapatalk

[OkiMarine]

Have you figured out why you were having take-down problems, just crud?

[Plain old Dave]

The back of the bar is warped.



Sent from my SM-J700T using Tapatalk

[OkiMarine]

Yup...that is without a doubt your problem. I bet you could straighten it out under a large press, a trip to a machine shop may be worth a try.

[Plain old Dave]

Got home and the tube cracked at some point or another and was brazed back together. You almost can't tell from the inside surface.

Sent from my SM-J700T using Tapatalk