Hey All,

Installing a Timney drop-in on a Savage 110 pre Accu-trigger.

I have two questions.

On the original trigger, there was a Trigger Pull Adjustment Spring. On the Timney there is not a place for this spring. I assume this is because Timney is using the spring on the set nut for trigger pull. But, because of uncertainty, i'm just verifying. I do not need that spring with the Timney Trigger?

Second question:
While adjusting the trigger, i can't seem to get it down below 4lbs without the trigger going off after a bump test. Is this a problem with the trigger, my setup? Anyone have any experience with this?