If it is a synthetic stock with the wood screw at the rear of the trigger guard, you can drill the hole out, fill it with epoxy. After the epoxy dries, re-drill the hole to the proper size for the screw. Then reinstall the screw.
I have a savage accustock trigger guard screw stripped on the stock. Any recommendation on how to repair this.
If it is a synthetic stock with the wood screw at the rear of the trigger guard, you can drill the hole out, fill it with epoxy. After the epoxy dries, re-drill the hole to the proper size for the screw. Then reinstall the screw.
Last edited by tom in michigan; 12-07-2015 at 01:18 PM. Reason: additional info
Yes it's synthetic will I need to remove the barrel from the stock?
You could probably do it with stock installed, but it would be easier if you remove the stock from the rifle.
Thanks for the info
Bookmarks