Trigger adjustment screw (something new for me)

[GUNFANATIC]

What is this screw at the back of a 1st generation SA trigger?
[img width=600 height=450]http://i32.photobucket.com/albums/d29/kmsguns/action003.jpg[/img]

[Blue Avenger]

read the tech section. Jim put a lot of work into it.


http://savageshooters.com/SavageForu...c,19414.0.html

[BillPa]

Me thunks the screw the lad is asking about is how the older trigger hinge pins were secured.

Bill

[GUNFANATIC]

No, I'm asking about the set screw on the "back of the trigger". ::)
Blue, the tech section doesn't address this one. I'm more than familiar with the normal two vertical ones as well as the one that some have on the front, but I've never seen this one before. As to the hinge pins, looks like it rivetted on.

[possum1]

Might have something to do with the horizontal wobble ???

[drybean]

that screw was used to secure the trigger pin on the old triggers

[BillPa]

No, I'm asking about the set screw on the "back of the trigger". ::) .

My mistake. The two rearmost screws, if its the trigger you have in the pic, do the same as the pre-ATs. The rear one is the safety adjustment, the second one is the trigger over travel.

Again looking at the picture the hing pin is a slotted set screw.

Bill

[drybean]

rear screw is safty adj the closet to the trigger shoud be overtravel adj

[GUNFANATIC]

No, I'm asking about the set screw on the "back of the trigger". ::) .

My mistake. The two rearmost screws, if its the trigger you have in the pic, do the same as the pre-ATs. The rear one is the safety adjustment, the second one is the trigger over travel.

Again looking at the picture the hing pin is a slotted set screw.

Bill

Well I'll be DANGED! Learn somethin' new every day. ;D I was talking about the slotted screw.

[dcloco]

Or...you have an aftermarket trigger. Two different brands of my aftermarket triggers have the mid trigger screw - keeps everything aligned.

[Blue Avenger]

Well I'll be DANGED! I was talking about the slotted screw.

so you weren't talking about what most of us would have called the back screw

[Blue Avenger]

Or...you have an aftermarket trigger. Two different brands of my aftermarket triggers have the mid trigger screw - keeps everything aligned.

most aftermarkets use a coil spring. that one has the wire spring.