Fixed front barrel sight

**Appleseed** · 06-04-2010, 05:57 PM

Do I have this straight...if I have a fixed front sight on a barrel, and change the barrel...does it indicate back to it's former alignment? What about using the same go/no-go gauges each time it's put back on to try and get head space the same? I noticed the last time I put back on a factory barrel, it was tight and the engraving was rotated a bit.

**Blue Avenger** · 06-04-2010, 06:12 PM

Originally Posted by appleseed

Do I have this straight...if I have a fixed front sight on a barrel, and change the barrel...does it indicate back to it's former alignment?

not very often when a different receiver is used

**Appleseed** · 06-04-2010, 09:14 PM

What about the same action and the same barrel, same gauges, same recoil lug?

**Blue Avenger** · 06-04-2010, 09:45 PM

should be ok. recoil lug makes no difference. No way you have the same gauge that was used at the factory

**Appleseed** · 06-04-2010, 10:44 PM

The barrel is an after market from Devin. If it gets good results, probably never take it off anyway, but trying to figure it out. So if I always screw back on the same barrel to the same action with the same head-space gauges, it will be close enough for govmt' work?

Looking forward to shooting some of the heavier stuff in the 8 twist .223.

Gonna go with the Williams sight on the rear.

Thanks.

**Appleseed** · 06-21-2010, 12:29 PM

Has anyone tapered the id of a barrel band? One like the Champion's Choice http://www.champchoice.com/detail.aspx?ID=1295
the barrel is lightly tapered from .750. Would this be the way to level the dovetail base instead of turning the barrel?