Results 1 to 5 of 5

Thread: Flush cup, Mess up

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    lrshooting
    Guest

    Flush cup, Mess up

    I couldn't find a gunsmith section here so I guess it goes here? Anyways, I put 3 flush cups in and the fourth was part of my badger BAR rail on my savage 10 that I put a McMillan on.

    Problem is I never thought to check the rotation of my cups because I wasn't thinking about the fact they are limited rotation. I messed up on one and now my rear bottom flush cup is rotated so that the sling attachment will not rotate perpendicular to the side of the stock. It's at an angle and looks like / rather than |. Is there a way to get these things out after they have been epoxied with jb weld?
    I typically heat jb weld up till it breaks the bond on metal parts (in general) but fiberglass resin is likely to break down as well if I do that. Only thing I can think of is drill them out but they seem kind of hard. My file looked like it was taking metal off but I might have to use hss or carbide drill I'm afraid.
    Last edited by lrshooting; 10-08-2015 at 10:47 AM.

Similar Threads

  1. Mark I/II/93R: Did I mess up buying a hmr 93r17?
    By delsol in forum Savage & Stevens Rimfire Rifles
    Replies: 4
    Last Post: 09-15-2013, 03:51 PM
  2. Barrel install did I mess up?
    By tacticalpanda in forum 110-Series Rifles
    Replies: 41
    Last Post: 04-03-2013, 02:08 PM
  3. Some of my Primers Not Seated Flush
    By beartooth91 in forum Ammunition & Reloading
    Replies: 12
    Last Post: 07-02-2012, 03:54 PM
  4. How badly did I mess up?
    By thomae in forum 110-Series Rifles
    Replies: 6
    Last Post: 08-08-2011, 10:18 PM

Members who have read this thread in the last 1 days: 0

There are no members to list at the moment.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •