Hello all, hoping to get some answers here. I am going to try to be less verbose than usual!

1 - Is there any benefit to bedding a Gen 2 (no wedge screw) Accustock? I find a wear pattern on my recoil lug which indicates uneven contact. How would one bed this lug, given the stock is intended to "flex" during installation of action?

2 - Used rifle, accuracy not awesome with factory ammo and various torque settings. (2" groups average with 4 different factory loads at 139 and 150 gr bullets). Expect most accuracy improvement from which of the following (budget reasons dictate can do all of these eventually but not at same time) : New (Shilen or Pac-Nor) prefit barrel, Handloading, or new (McMillan) stock glass bedded?

3 - If I bedded my current or future stock, and replace the barrel, does the bed job need to be re-done? I assume it's a definite yes if the recoil lug is replaced during the barrel replacement, but what if it isn't?