So I have a 308 model 11. I upgraded the Nikon scope to the Nikon M308 4-16. Using the original rails doesn't seem the scope has sufficient adjustment to zero scope with laser sight. Is there any adjustment that can be made in the rails?
Thanks
Jfrano,
What lack of adjustment do you have? Windage and/or elevation? I assume you have individual bases on the receiver. They are what they are short of bedding them for height alignment. Whereas a solid one piece picatinny rail (bedded if needed since some receivers have a height difference front to back) would be much easier.
Snipe
Did you change rings also?
Have you shot this rifle before?
That scope is of known quality.
Last edited by Robinhood; 09-22-2015 at 08:02 PM.
The Dunning-Kruger effect is alive and well.
Nikon's web site says it has a built in 20 MOA slope.
What base are you using?
The elevation. I can't get cross hair into laser
Point, crosshairs are low
--No stock savage rings.
--Had the rifle for a year and have shoot many rounds.
--purchased m308 from Optics Planet
Shoot target at 25 yards Adjust elevation(will be 4 to 1) Stop when you are 1.5 low. move to 50 then 100.
The Dunning-Kruger effect is alive and well.
Members who have read this thread in the last 1 days: 0
Posting Permissions
Reply With Quote
Bookmarks