1960 110

[Lone wolf 5575]

To make a long story short the stock broke right where you put your hand around when I was shooting and ever since it is not fired right there is no take up in the trigger and the trigger Pull feels heavier I may be missing something I don't know I know I have asked this on here before but I still can't figure out how to fix this problem thank you.[IMG][/IMG][IMG][/IMG][IMG][/IMG][IMG][/IMG][IMG][/IMG]

[Lone wolf 5575]

[IMG][/IMG]

[Lone wolf 5575]

[IMG][/IMG]

[Bolthead]

Hard to tell from the pictures, but something got bent somewhere, most likely the trigger, one of the pivot pins, or the bracket. I take it that is doing this out of the stock. This is so different from the newer triggers. Did see some similar parts on Ebay recently. Seems like the bracket would be the most likely suspect. Good luck with it. Wish I could be more help.

AP

[Lone wolf 5575]

thanks in or out of stock its the same I have been to 2 gunsmiths and they have been no help. I don't think I can fix this myself at this point it just may stay in the safe.

[Lone wolf 5575]

The gun will still fire when the safety is engaged

[darkker]

Pictures don't let you "feel" what is going on, but since the photo of "Stone here", did you stone something yourself??
IF there is no "Take up" sounds like you changed the angles enough to have things..."ready to drop", as it were. Stoning angles can take a 2-stage trigger and make it a single.

Otherwise I agree with the above, something could be bent. How in the world did the stock break?? if you had a violent even then bent is certainly very likely.

[Bolthead]

Very interesting that it will still fire with the safety ON. If you can figure out why it is doing that, it may give some insight as to why the trigger pull is doing what it is doing.

[LHitchcox]

The safety screw is out of adjustment.