Reply With QuotePretty sure the only screw holding it on is the furthest one towards the back of the top tang, once it's removed the stock should just pull off.
I mentioned in my introduction that I recently acquired a fairly decent model 1903 pump 22. Internally in great shape, externally had a little more "patina" than I care for...most of which was removed w 4/0 steel wool and WD40. The stock is in pretty good shape except for a small repair on the lower tip which I want to deal with, but the overall finish was pretty crummy so I also want to refinish that. Can anyone give any tips on removing the stock on the model 1903..if you've had any experience w that? Thanks very much for any input.
Randy A.
Pretty sure the only screw holding it on is the furthest one towards the back of the top tang, once it's removed the stock should just pull off.
Savage- "never say never".
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks