Randy,
I'll be building the model of the action to exact measurments.
Later in CAM stage, I can tell it to cut extra out on the sides and even more on the bottom.
Last time (220-Swift stock) I was using different CAM software. I could only tell it to take out extra as a function of the bit...so 10% more, or something like that.
Yes, I'll inlet extra material removal to allow for bedding.
I can test fit the barreled action while the stock is still set up in the mill vice...then tell the code to cut a bit further if necessary.
Same with the bottom metal (PTG Stealth). Model, cut, test fit, asjust, cut again.
Bookmarks