Cheek rest

[shooterfpga]

Anyone know of any kydex cheek rests that have 2.5" hole spacing? I have pre-existing holes drilled that id like to match up with one. If not ill fill em and redrill or make my own sheet with the same spacing.

[thomae]

I guess no one does. I'd suggest that you make your own. After all, how hard can it be?

[shooterfpga]

Done. Ignore the bondo. The stock is getting painted over so i used it to fill the holes and drilled new ones.

Cheek rest has been slotted to make use of sling studs. Bolt can still be removed with no notching of the front.

[thomae]

Looks good.

[shooterfpga]

Thanks. I have a boyds im debating on doing a loggerhead on. I would through a kydex on it with a countersunk grommet to keep it from splitting but im not sure how well that would work. I think the diy cheek riser from this site or the loggerhead would be better for a laminate for strength.