If the firing pin you currently have is adjustable, you should be able to use it with the new bolt head, just reset the protrusion before use. Your new bolt head will need an ejector, spring, and retaining pin, and you'll need to remove the standing ejector from the receiver currently used by the CRF system. You'll also probably need a new magazine box and follower, I believe the feed lips are too short on the WSM box and will cause the 284 cases to attempt to load high - jamming them into the breech face. You'll also need to make sure that the barrel you get matches the shank of your WSM receiver, either small or large shank. You'll also need a headspace gauge. That should about do it.
Bookmarks