Results 1 to 4 of 4

Thread: Bas

  1. 01-11-2015, 10:22 PM #1
    reynoldsfamily3
    Guest

    Bas


    I am trying to find out if there is a recommended or commonly used amount of torque for tightening the BAS. I have searched, but the only answer I have found is "tight" and "very tight". Does anyone use a certain setting?

    Thanks
    Bill
    Reply With Quote Reply With Quote
  3. 01-11-2015, 11:42 PM #2
    olddav
    Status
    Offline
    Basic Member
    Join Date
    May 2011
    Location
    Lower Alabama
    Posts
    1,091
    No torque setting required for BAS, just crank on it a bit.
    Reply With Quote Reply With Quote
  4. 01-11-2015, 11:43 PM #3
    bootsmcguire
    Status
    Offline
    Basic Member bootsmcguire's Avatar
    Join Date
    Jan 2010
    Location
    Iowa
    Posts
    2,892
    Just nice and tight by hand.

    No need to additional torque, the flange of the BAS should stop once it pinches the bolt handle to the bolt body.
    204, 22 K-Hornet, 222, 223, 22-250, 22-250AI, 6BR, 243, 243AI, 6-06, 6-WSM, 250-3000AI, 270, 7-08, 7RM, 30BR, 308, 30-06, 375 H&H, 444 Marlin, 450BM, 458WM
    Reply With Quote Reply With Quote
  5. 01-12-2015, 08:59 AM #4
    reynoldsfamily3
    Guest
    Thanks Guys
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Members who have read this thread in the last 1 days: 0

There are no members to list at the moment.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules