Use penetrating oil, flush crud out, use more oil, smack it face down onto the bench top
I shot some fine quality Winchester ammo (Premium) and had a couple primers back out; this caused my ejector to stick inside the Bolt head (or break off and stick into the bolt head). The bolt is dissasembled, but the plunger parts are still in bore except the retaining pin. Any idea's about getting the rest out?
Use penetrating oil, flush crud out, use more oil, smack it face down onto the bench top
When you get the tip of the ejector protruding from the bolt face, use some of the needle nose visegrips to pull it out. They seem to work better for gripping it than regular pliers. This was recommended to me when I had one stuck a while back and it worked well. Good luck.
Dennis
Thanks for the info!
Another question; Where do you recomend I get the replacement parts at? (plunger, spring, maybe pin)
Brownells 1-800-741-0015
or
Savage 1-413-568-7001
If the above doesn't work, stick the point of an electric engraver into the hole and touch the ejector. A few seconds of this and then slowly pull the point out of the hole. Usually the ejector follows it.
Never kick a fresh turd on a hot day- Harry Truman
Had to drill it out, came out with the drill.
Spring had to be dug out.
Brownells to the rescuefor replacement parts.
Savageshooters forum to the rescue again! Thanks, one more stuck pin over come!
kdvarmint.
Bookmarks