Accustock Screw Sequence Help. . . with pictures.

[ravot22]

I haven't removed the barrel from the stock. I want to try different torques in an attempt to improve accuarcy.

What's the sequence?

I've done advanced searches on this topic(here & on youtube), but I'm a visual learner.

So I don't get confused; we'll call:

#1 Screw (all the way to the left in the picture)
#2 Screw (just to the left of the magazine release)
#3 Screw (under the bolt release)
#4 Screw (all the way to the right in the picture)

Thanks in advance...

[Robinhood]

Remove all of the screws accept for the #4 screw.
Remove barreled action from stock by removing #2 and @3 screws.
Take #1 screw and the lug tensioning key it is threaded into and place it in a small plastic bag and set it to the side of your bench.
Reinstall barreled action.
Run #2 &#3 screws down finger tight or until you feel resistance.
Tighten #2 to 40 IP's
Tighten #3 to 40 IP's
If you didn't remove the lug tension key you can now tighten it to 40 IP's