Small shank unless it is a WSM Striker.
Basailly what I'm interested is what rifle pull off barrels will fit the Striker I know they would have to be cut to pistol leanth
Thanks
Small shank unless it is a WSM Striker.
"Muzzle velocity is a depreciating asset, not unlike a new car, but BC, like diamonds, is forever."-German A. Salazar
Ok thanks so any small shank from any Savage rifle will fit a standard Striker
taking in fact of only using short action cal.
Use can use any of the small shanks on them, even long action cartridges.
More shooting, less typing.
Yup you can use Long action stuff like 30-06, 25-06, etc., but they obviously wont feed from your magazine. You also may have to pull the bolt to remove a loaded round, but fired brass will eject fine. You should be able to also use things like 7RM, 300WM, etc., but you will need to acquire a SA-Mag bolt head for those and same as above, single shot only, remove bolt to remove loaded round.
204, 22 K-Hornet, 222, 223, 22-250, 22-250AI, 6BR, 243, 243AI, 6-06, 6-WSM, 250-3000AI, 270, 7-08, 7RM, 30BR, 308, 30-06, 375 H&H, 444 Marlin, 450BM, 458WM
Yep on the feeding single shot I have a striker in 6.5 x 284 that to seat the bullet were I like they wont fit the magazine
I'm adding a single shot bench rest follower to it.
my next build more than likly be a Mcgrown prefit in 6br. But I'm running across a few interesting pull off barrels that I could end up using for this or another project
thanks
Bookmarks