Results 1 to 20 of 20

Thread: First PBR match

  1. #1
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879

    First PBR match


    Went ok for shooting in winds up to 30mph in the mountains of Lytle Creek, CA.

    Placed 9th out of 17, but took top 308 out of the 4 or 5 of us.

    The wind was serious and largest targets were 2 MOA at 500 yards.

    Great time, great bunch of guys, I'm hooked!

  2. #2
    Basic Member
    Join Date
    May 2012
    Location
    Portlandia, Or.
    Posts
    428
    I didn't think there was a place with more wind then down there till I started hunting in eastern Montana! Sounds like a lot of fun.

  3. #3
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    It was ridiculous yesterday. Between actions full of sand and everything it was definitely a test of man and equipment. I had some malfunctions myself which after about an hour of getting the sand out of all the nooks and crannies lead my to some more home gunsmithing adventures. I had to grind down and polish up the feed ramp and spend some more time tuning up the AICS mag I have. Accurate mag seems to run without issue though. Some minor tuning Still to work out, but I'm also waiting for a new barrel from Apache. Going to switch over to a 6mm and be ready for the start of the 2015 season if I can manage to make some more of these events and get some good practice in.

  4. #4
    Basic Member
    Join Date
    May 2012
    Location
    Portlandia, Or.
    Posts
    428
    It seems like all these matches in the west are held in the worst conditions known to man! I have been really fortunate as my rifle has never quite on me. My scope has failed and I have failed the rifle just keeps on shootin. I run my bolt gun dry and carry a chamber brush and some hoppies in a little bottle. When things start to go south I run some hoppies on the chamber brush and then rap a patch on the brush to clean it out. Then I wipe the bolt down with a rag and more hoppies and then wipe it all off. Its ready to run again. The mag thing must be gun specific cause I had a lot of problems with accurate mag. Never tried AICS. Still had fun, right?

  5. #5
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    For sure! Maybe you can make it out to one of the monthly matches, so I'm not the only barrel nut on the line.

  6. #6
    Basic Member barrel-nut's Avatar
    Join Date
    Dec 2010
    Age
    53
    Posts
    1,067
    Somebody callin me??

  7. #7
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    Maybe....

  8. #8
    Basic Member barrel-nut's Avatar
    Join Date
    Dec 2010
    Age
    53
    Posts
    1,067
    Wish I was closer, I'd love to shoot in that kind of a match. Nothing like that here. Congrats btw!

  9. #9
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    [IMG][/IMG]

  10. #10
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    Top 308!

    [IMG][/IMG]
    Last edited by LoneWolf; 11-18-2014 at 11:51 AM.

  11. #11
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    The Wind....
    [IMG][/IMG]

  12. #12
    Basic Member
    Join Date
    May 2012
    Location
    Portlandia, Or.
    Posts
    428
    LoneWolf, My brother lives in Sherman Oaks and I been wanting to get down there and see him. And bring some guns. That would be good!

  13. #13
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    http://www.socalprecisionforum.com/viewforum.php?f=5 Register here for the Monthly Match Notice.

  14. #14
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    Today's COF was as follows.... However they weren't in this order
    Stage 1 - Warm up towel head
    Targets - (2) IPSC flappers @ 395yds, (2) 8" hanging @ 515yds, (2) Skinny sammies flappers @ 310yds, Taliban target @ 150ish
    75 seconds
    (7) rounds
    Starting prone with mag in, bolt back.
    On beep shooters will engage the taliban target with 1 round) then engage their 395yd flapper with 1 round, then engage the 515yd plate with 1 round, then the 310yd flappers with 1 round. Then repeat on steel only!!
    Cold bore hits were made Darren,Solo & myself
    Joe H, Phil, Larry, & Eddy all had 2 hits on steel for the rest of the stage (highest for the stage)

    Stage 2 - Holdovers (2 shooters at a time)
    (6) Rounds
    Shooters begin prone behind rifle, bolts back.
    Targets- 310yd skinny sammys , 395yd IPSC flappers, & 515yd 8" plate
    10 pts per hit
    60 sec prep time
    Starting prone with bolt back
    On beep shooters will have 90 seconds to engage 310yd skinny sammys , 395yd ipsc flappers, & 515yd 8" plate from near to far then repeat. Shooters will advance to next target if they miss shot. Once stage begins shooters may not touch their elevation knobs.
    Evin,JoeV,Jason, Danny all had 4 hits for a stage high score


    Stage 4 - Long range steel circles 12"
    This stage replaced our paper long shot stage because the wind was blowing so hard the paper stands & targets weren't holding up..... So the shooter had 30 sec to send 5 rnds down range & hopefully hit the huge steel.. With this much wind it was very hard to make hits.
    Solo was kickin ass with that gasser scoring 4 hits for the highest score.

    Stage 5 - Pool balls
    Targets - 150yd blue / purple pool ball paper, 310yds (any size) red, green, brown, 395yds (any size) orange, yellow. 515yds black.
    120 seconds
    (10) rounds
    Starting prone with mag in and bolt back
    On beep shooters will engage pool balls in order of 1-8. All targets must be hit to advance and they must be hit in the correct order or the player will "scratch". The Black 8 target will be worth 30 points but a miss on this target counts as a "scratch" and a zero for the stage. The order & color of the balls were given just prior to shooting.... This was a fun stage
    Evin & Joe V had 5 hits each for this stage.

    Stage 6- tank trap hostage
    Target - 250yd hostage IPSC
    60 seconds
    (5) rounds
    Starting port arms
    On beep shooters will engage hostage taker 5 times. -10 for hostage hits.
    Joe H, Aaron, Solo & Evin all scored 3 hits.


    Stage 8 - roof top
    Targets - 310yd 10" white & 395yd 12" white
    90 seconds
    (6) rounds
    Starting port arms with no gear staged on prop
    On beep shooters will run up roof top and engage 310yd target with 1 round. Then transition to 395yd target and engage with 1 round. Repeat process until all 6 rounds have been fired.
    Jason took this stage with 4 impressive hits on the rocking rooftop. Awesome shooting Jason!!

  15. #15
    Basic Member
    Join Date
    Jan 2014
    Location
    Louisville, Kentucky
    Posts
    861
    Sounds like fun!!
    AXIS 7mm-08 , 22-250

  16. #16
    Basic Member
    Join Date
    May 2012
    Location
    Portlandia, Or.
    Posts
    428
    Very good COF. If timing is right when I come down, I'll slip away and shoot with you guys. Does it fill up or are there spots open?

  17. #17
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    I don't think they really have a limit. If you get on the forum just try to RSVP, so they can plan if they have a large amount. They ran two COF's simotaneously.in some instances.

  18. #18
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    Oh and this one was cut short due to the conditions.

  19. #19
    acemisser
    Guest
    must be a ***** with that brake in your face.

  20. #20
    Basic Member
    Join Date
    Jun 2013
    Posts
    2,879
    He was spotting during that round!

Similar Threads

  1. Shilen Match or Select match
    By wjchastain in forum 110-Series Rifles
    Replies: 4
    Last Post: 05-04-2015, 07:01 PM
  2. Shilen Match or Shilen Select Match?
    By Captk in forum 110-Series Rifles
    Replies: 12
    Last Post: 03-16-2014, 01:43 PM
  3. Replies: 5
    Last Post: 11-02-2013, 07:59 PM
  4. M118 Match vs Mexican Match
    By pbcaster45 in forum Ammunition & Reloading
    Replies: 9
    Last Post: 02-05-2011, 08:46 PM
  5. Shilen Match VS Select Match barrels
    By 82boy in forum 110-Series Rifles
    Replies: 19
    Last Post: 08-02-2010, 12:02 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •