PTG Bolt Head and Bolt Body: What Fitting is Required?

[michaelnel]

Hi Folks

I have a Savage 12 Benchrest in 6mm BR. I have ordered the following and will receive them early next week:

Criterion 30" Bull Barrel in 6mm BR
PTG bolt head
PTG bolt body

PTG makes vague references to a need for gunsmithing to install the bolt head. I believe they just mean that I must do the headspace measurement with this assembled bolt, but I am not sure if I need to do more. I have emailed them, but no response.

I do understand that I need to set the headspace with the new barrel and bolt, and I have the GO gauge (and will use the tape trick for NO GO). I have installed a Criterion barrel before, successfully, on my .308.
'
Anything else I need to do for this job other than setting the headspace with the new barrel and the bolt with the new body and bolt head? I would think that with the floating bolt head design that lapping the lugs should not be necessary, but I am often wrong.

Thank you!
Michael