Results 1 to 8 of 8

Thread: PTG Bolt Head Firing Pin Hole Issue

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Basic Member
    Join Date
    Apr 2011
    Location
    Virginia Beach Va
    Age
    63
    Posts
    324

    PTG Bolt Head Firing Pin Hole Issue

    OK, searched and didnt see this sooooo here it is...

    Older 110FP in 300WM as a donor action...

    Ordered a new PTG .473 Bolt Face for LA .500" lug...

    I see where some people have an issue with small vs large firing pins and have to drill out the shank with a #25 (.1495") bit...not the problem here...its the actual firing pin portion of the firing pin will not fit into the new PTG firing pin hole...the shaft of the firing pin fits perfectly into the shank and then seems to strike the shoulder of the hole from the inside...so...what do I do? Drill the firing pin hole itself? If so what size?

    ETA...just put a mic on it as near as I can tell its .070" ARE THERE TWO DIFFERENT SIZE FIRING PIN HOLES?

    Thanks

    Capt Beach
    Last edited by CAPTBEACH; 10-18-2014 at 01:09 PM.

Similar Threads

  1. 62/64-Series: 64F Firing Issue Bolt Assembly
    By Salyers in forum Savage & Stevens Rimfire Rifles
    Replies: 0
    Last Post: 05-29-2016, 10:33 AM
  2. Replies: 7
    Last Post: 03-10-2013, 03:36 PM
  3. Bush Firing Pin Hole for 308 bolt-face?
    By jinx-) in forum 110-Series Rifles
    Replies: 2
    Last Post: 06-24-2011, 11:53 AM
  4. Replies: 5
    Last Post: 02-24-2011, 09:16 PM
  5. bolt head question about the size of the fireing pin hole
    By camoman83 in forum 110-Series Rifles
    Replies: 1
    Last Post: 12-08-2010, 06:32 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •