Axis II Sear Spring Assembly Help Needed

[jimhoodag]

I took the accutrigger off of my Axis II and can't figure out how to reattach one of the sear springs. This trigger appears to be different from the one on my Savage 110. Unless I dropped it, it does not have the spring with two legs that fits between the bolt release and receiver. There are two coil springs on this trigger: one that is about 3/4" that fits on the left, outside of the trigger housing between the housing and the sear and the other spring is about 3/8" long and I can't figure out where it goes. It has to put pressure on the sear somehow to make it fire.

I can't find a diagram of the Axis II accutrigger, but from the few diagrams I have found of older accutriggers the spring appears to be number 4B; however, the diagrams do not show where it goes.

Jim Hood

[short round]

Remove trigger housing, near action screw threads, is a drilled hole for spring, spring puts pressure on trigger housing. Does not have 110 type sear spring.