Earlier this week I pulled my action out of my Boyd's Prairie Hunter stock to install a different trigger spring and when I put it back together the trigger kept jamming up. I got so frustrated that I put the action back into the Accustock that was on the rifle when I bought it. Trigger works perfectly now.



I hope I didn't over tighten it. I use a fat wrench and used 30 inch pounds on the front and 25 on the rear.

I'd like to repair the stock rather than pursue having Boyd's replace it. Any ideas on how to do it? I'm up for combining a stock repair with bedding the action at the same time.

Thanks,

Szumi