Would this work
http://www.midwayusa.com/product/698...ies-steel-blue
I've been searching for a blued thicker recoil lug for my 110 build and can't seem to find any...all stainless. Anyone know of someone that makes a blued one? Thanks
Would this work
http://www.midwayusa.com/product/698...ies-steel-blue
AXIS 7mm-08 , 22-250
I don't think you are going to have much luck. I take the stainless one's, rough up with sand paper, clean with acetone, spray with satin black GunKote and bake for 1-hr at 325F. It is resistant to chemical solvents unlike regular spray paint.
You'll have to cerekote a SS one or go with the standard savage one
Just by a chrome moly lug and cold blue it.
http://www.midwayusa.com/find?userse...earchscope=all
Bill
Each morning eat a live green toad, it will be the worst thing you'll have face all day.
Ok thanks guys....after looking at the one's at Midway I'm a little concerned about fit. It reads gunsmith required and doesn't state if it's for a small shank or large. Also if it doesn't come with a roll pin installed what size is the aligned hole? is it a standard size hole? Anybody know
Last edited by dale1386; 08-10-2014 at 05:14 PM.
I believe the hole is std and drilled for a roll or spring pin. You could tap it out and use a small screw like sss does which is just a turned down 4-40 screw.
Willing to give back for what the sport has done for me!
Each morning eat a live green toad, it will be the worst thing you'll have face all day.
Bookmarks