112 single shot 1st gen

[7.62WAM]

I am looking for a part number for Redfield Weaver or Burris one standard piece scope base.
Any body have any old charts? Ive tried several place but they are the wrong hole spacing.
Thanks

[bootsmcguire]

Which screw spacing is your action?

If it is the 5.062" then any base for a flat rear long action should work perfect. If it is the 4.52" spacing then you will need one for the intermediate action, and that may be tough to find, I am not sure if they still make one for that.

I just cruised the Weaver and Burris websites before posting this and couldn't find a 1pc listed for the 4.52" spaced actions.

hope some of that helps, Good luck.

[Nor Cal Mikie]

I looked for a LONG TIME but couldn't find one for the 4.52. Most were listed to fit but in the end, none of them fit like I wanted. Tried a two piece mount but didn't care for how it looked and I really wanted a one piece mount so I finally took a couple of new Leopold mounts with the rear windage adjustment, sent them to a friend and had him cut, fit and weld them together to make a "custom" mount. The mount doesn't hang over the port opening and "all the screw holes" match. Looks "as new".

[7.62WAM]

Thanks for the replys I was afraid they were not available any more, I was hoping some one had one installed and had a part number, I guess i'll use a two piece or make one up.
Again thanks for the replies