The CDI conversion comes with a schematic of the measurements, although it is lacking a few dimensions. It is pretty much the same as the inlet for a center feed factory bottom metal.
I have a Stockade Woodchuck inletted for an internal magazine. I am going to inlet the stock for CDI DBM.
The CDI metal is supposed to set at the same depth as factory Savage DBM. Can anybody give me the correct measurement from the bottom of the action to the top of the DBM, front and rear?
Stevens 200, .260/ Sin Arms Brux #7, 24"/ Stockade Woodchuck/ Rifle Basix SAV1/ Nikon Buckmaster 4x-14x-40mm
The CDI conversion comes with a schematic of the measurements, although it is lacking a few dimensions. It is pretty much the same as the inlet for a center feed factory bottom metal.
"As long as there's lead in the air....there's still hope.."
Thanks. I just received the CDI bottom metal and the drawing that came with it has enough to get me going.
Stevens 200, .260/ Sin Arms Brux #7, 24"/ Stockade Woodchuck/ Rifle Basix SAV1/ Nikon Buckmaster 4x-14x-40mm
Bookmarks