Bolt handle removal

[jsthntn247]

I purchased an aftermarket bolt handle to replace the factory one. The big nut on the back of the bolt handle seems impossible to break free. Is this normal, any suggestions on how to get it off?

[drybean]

install you allen wrench in the nut, set it on the floor (carpet) then step on it

drybean

[floydboy]

Sometimes when it breaks loose the pop will make you think you broke something in half. They can be very tight. Don't even try to tighten it back that tight.

Floyd

[jsthntn247]

install you allen wrench in the nut, set it on the floor (carpet) then step on it

drybean

Think I might have to put mine in a vise and use a impact wrench. It's seriously on there.

[FW Conch]

If you have a vise, install the bolt handle in padded jaws, insert an Allen head socket with a breaker bar, a 2 ft. pipe on the breaker bar, and lean into it slowly until it breaks loose. Don't use the impact wrench.

Good Luck.......Jim ;-))

[bootsmcguire]

Give THIS a read. I think it will be of help. Works every time.


I see Drybean already touched on it, the link has some pics showing how to:

[EdKin]

Give THIS a read. I think it will be of help. Works every time.


I see Drybean already touched on it, the link has some pics showing how to:

+1 worked great for me

[1.618]

Think I might have to put mine in a vise and use a impact wrench. It's seriously on there.

I put the Allen wrench into the bolt, then held the bolt in my left hand with my index finger wrapped around the bolt handle, then rapped on the Allen wrench with a hammer. Broke it right free. Same idea, but without the vise or impact wrench. Kroil might also help.

[Badger]

+1 worked great for me

Worked like a charm, thank you guys. I used a Husky all in one allen wrench group and it still worked on the floor, loud pop and everything!