I think this is the information you seek?
http://www.savageshooters.com/showth...e-Easy-Take-II
Hello,
I'm sure that there has been many posts on this, but I'm unable to seem to find them. I would like to be able to stiffen the front part of the forearm. I would like to inlay the forearm so that I could use carbon arrows cut to length and glue in or use accugel or devcon.
To open the channel up, I will use a doll rod wrapped with sandpaper. This will allow me to use the bigger barrels in the factory plastic stocks. The best that I can tell, my stocks that I have, look to have steel pillars in them. Their was a post somewhere that had very good photos of in letting the forearm and the receiver.
I have two long and short actions that I will need to glass bed and stiffen the forearms of the stocks. One of the long actions is in 7MM Rem Ulta mag.
Any and all help on this topic I say thank you.
[FONT=Comic Sans MS][SIZE=3]U.S. Army Retired Disabled Veteran[/SIZE][/FONT]
I think this is the information you seek?
http://www.savageshooters.com/showth...e-Easy-Take-II
Originally Posted by keeki
Guess it doesn't really matter. If ya cant afford $15, you won't be buying much anyways
Thanks. Their is good information but was looking more on the bedding side.
[FONT=Comic Sans MS][SIZE=3]U.S. Army Retired Disabled Veteran[/SIZE][/FONT]
Try here:
http://www.6mmbr.com/pillarbedding.html
Originally Posted by keeki
Guess it doesn't really matter. If ya cant afford $15, you won't be buying much anyways
Bookmarks