Hey guys,

I took a snap shot of my new bolt design. Also noticed some members asking how the springs go together.
It is a new design - I think savage is trying to speed up or cut down on machining costs.
What baffles me is why they use 2 springs in the main body?
Why not just tackle the pin retaining spring and main spring in 1 shot..... And then a single round coil between the two. Such stupid logic.

Does a bolt lift kit exist for this setup? I am not sure how one would incorporate it any way.
I am looking to lessen the bolt lift on this new rifle, Wife says it takes quite a bit, And I agree.

Removing that single coil helps a bit, I will be polishing mating surfaces in the days to come.

Take care guys