I bought this old 110 sight un-unseen with the intention to re barrel it from the get go. This is the same one I am planning on shipping to McGowen for them to re blue the action and re barrel. The gun was advertised as having a "tuned factory trigger" set to just under 3lbs. I dont know what all was done but this thing has zero take up. The bigger problem is I can get the sear to fall with the safety on with pretty steady pressure on the trigger. I have adjusted the safety screw to the extreme and the only way to keep it from happening is to adjust the screw to the point the trigger is locked solid. Any movement at all and I can make it fire on safe. When took the trigger group apart and started looking at things it is pretty obvious the the edge of the sear is not straight. One corner is higher that the rest of the edge. When everything is together and the the rifle is cocked I can see light between the sear engagement surface and trigger. Is this the result of a trigger job gone bad or could there be something else I am over looking? I am use to AR triggers and from experience with those I dont think I have near enough engagement. I tried taking pics of the sear with my phone but they arent clear enough for me to even bother posting. Is there anything else I need to check or if I just need to buy a new sear where can I order one online? Oh and I forgot to mention this is a two screw trigger so there is no sear adjustment screw.