I don't own one of these trimmers, and it looks like a nice addition to the reloading bench. I do offer the following observation:
As the OP mentioned, this type of trimmer indexes off a datum somewhere on the bottleneck.
If there is any difference in sized brass, there will be a corresponding difference in trim length. This is not normally a big problem as most hand loaders size first before trimming (I think), but if you are using different brass, different dies or have the same chambering in more than one rifle, it is something to consider if you are trying to eke out the absolutely most consistent loads and brass.
As best as I have been able to discern by searching the internet, (I did not contact the manufacturer)retail price is in the $350 range.
It makes me wonder if I could make something similar using a small router. (I don't need any more projects, just thinking out loud.)
Bookmarks