You did a fine job building the vise setup. Now your hooked for sure. Welcome to "The Brotherhood".
Whew !!! That wasn't too bad, my first barrel swap is 1/2 way there. :)
I'm a sucker for a good DIY so, I set off on building my own Barrel vise and Action vise for my first barrel swap. I set the action up, made it nice and snug, gave the barrel nut wrench a tap-tap and off she came !!
[img width=600 height=450]http://i227.photobucket.com/albums/dd84/Shovelheadave/Actionvise1.jpg[/img]
[img width=600 height=450]http://i227.photobucket.com/albums/dd84/Shovelheadave/Actionvise2.jpg[/img]
You did a fine job building the vise setup. Now your hooked for sure. Welcome to "The Brotherhood".
Vietnam Vet, Jun 66 - Dec 67
Good job. What diameter hole in your clamp block? Now that you got that old action off that nice barrel..........just send it to me. ::)
1.25"Originally Posted by slurpin dog
Head spacing set !! I'm ready to roll.
Can't believe how easy the whole process was. I can see how it turns into an obsession.
Thanks for all the tips boys.
Bookmarks