Take the parts out of your box mag and put them in a blind mag stock with an L bracket.
I can not seem to find a straight forward answer to this. I bought a model 11 center feed 6.5 creedmoor for a build. Can one take this gun that had a dbm and use a blind mag stock? Is so what has to be done to make it work?
Thsnks
Take the parts out of your box mag and put them in a blind mag stock with an L bracket.
Ok. I'am assuming that I need to buy a l bracket? Anywhere to get one other than savage?
Actually you don't need one. Take a little plumbers epoxy putty and use a small amount in the bottom corners and bed it to the stock ( use release agent for removal) or use wood shims glued in place to fit it. Either way works.
FROGGY
See profile for fire arms
Do it today there maybe no tomorrow
That will work IF the depth of the inlet for the magazine box is correct. If it's too deep and you do that the box will be to low and the bolt won't be able to strip off a round as it passes over.
L-bracket can be had from Savage and ensures the magazine is at the proper height in relation to the action.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
Well I guess the older I get the more I" assume", because I would make sure it fit and functioned before I would do final assembly. My thoughts are any reasonable person would do the same.
If I remember correctly your very good friend once recommended the same thing here on the forum and I am 110% positive he knows alot more than any of us.
FROGGY
See profile for fire arms
Do it today there maybe no tomorrow
Bookmarks