Hello,
Been using an RCBS Turret press for a short while now. (couple of months)

I'm having issues crimping the bullet tight enough into the case.

I have both FL & neck sizer dies.

I used an unfired case/ round, to set my "depth" of how far the case will travel into the die. (and a smidgen more)
and then turned down the bullet press until it touches the top of the round - for seating depth.

Every once in a while, I find the bullet is not crimped into the case tight enough. I can push it in by hand into the case.

Now when I have the case travel into the die further, it crushes the taper portion of the case.

Its like the bullet seats, and crimps tight, then gets pushed further down, crushing the case. (exactly - duh)
So I backed off of the depth, but now the rounds do not seem tight ALL the time in the case.

This is very frustrating to find that sweet spot.

Could someone point out some helpful hints.
I've used a Dillion is the past, but this is my first set up with a "Shouldered" case.


I have watched several How to videos, but I can not find a set up video for this press.
I understand the basic principles, and it "gets me by" but I want it correct, not close.

Much appreciated,
aka:Cliff