Stock Torque setting for Model 12 3 screw target action???

[k80skeet]

Does anyboby have the correct torque setting for a model 12 target stock with 3 screw target action????????????

[darkker]

There isn't one.

[jhelmuth]

LRPVs in the HS Precision stock is 55-60 inch pounds. That comes direct from the factory.

Laminate stocks with pillars are typically 40-45 inch pounds if they are bedded, 25-30 if they are not. That is a generalization (ymmv).

In the 3 screw configuration, I find that having the rear screw 5-10 inch pounds less works well....


Good shooting....
Jim

[FW Conch]

I have always wondered about the 3rd screw? It seems like it could provide the potential for uneven stress or binding if not handled correctly?

[Alleycat72]

I run 30/30/15

[frank1947]

Trial and error maybe but i do 50 on all of them, I have tried differnt settings but I never see any difference, I kind of look at it this way, if glueing a action in to a stock is the best thing you can do then tight is good. IMHO

[wareagle69]

http://www.accurateshooter.com/techn...torque-tuning/

The above might be of interest

[Stockrex]

When I asked this - gods responded with finger tight.