Anyone still putting the spring washer in between the baffle and lug instead of behind the baffle (factory location) ? What is the benefit ?
The back of my lug has a slight radius so the washer won't fit between the lug and baffle. The only thing I could do is open up the washer hole size. Is it worth doing ?
You'll have to open the ID of the washer "Slightly" to clear the fillet(radius) at the lugs, but don't enlarge it too much or it can drop down and hang up on the edge of the action lug recess then you'll be buying a new one. Experience is a good teacher BTW!
When I'm truing a bolt head I'll remove the fillet and leave the washer as-is.
If its worth doing is pretty much up to you.
Bill
Each morning eat a live green toad, it will be the worst thing you'll have face all day.
At times, sure. Its a left over when the bolthead are machined, a result of the radius on the tip of the tool bit. If I'm squaring the BH face it a simple matter to change to another holder with a right hand bit and make that cut then relocate the spring washer when I reassemble the bolt.
Each morning eat a live green toad, it will be the worst thing you'll have face all day.
Bookmarks