Reply With QuoteThat thing looks huge. I thought I made mine a little on the big side. You should not have any trouble getting a hold of that thing even at -20*F with two sets of gloves.
Looks good and hope it works good for you.
I made the bolt handle extention from a large roller bearing. Shaped it with a bench grinder. The bolt handle I used a dremmel to get the ball ground down.
That's about it, I pillar bedded it into my new Boyd's thumb hole stock. I'm waiting for my DNZ Gamereaper mount and Nikon Prostaff scope to get here and ill be ready for deer season.
That thing looks huge. I thought I made mine a little on the big side. You should not have any trouble getting a hold of that thing even at -20*F with two sets of gloves.
Looks good and hope it works good for you.
204, 22 K-Hornet, 222, 223, 22-250, 22-250AI, 6BR, 243, 243AI, 6-06, 6-WSM, 250-3000AI, 270, 7-08, 7RM, 30BR, 308, 30-06, 375 H&H, 444 Marlin, 450BM, 458WM
Looks good although, I have a "private bolt handle maker" I use...
What was the goop you used for filler?
Nice job, by the way.
'Scuse me while I whip this out...!
He used goop too. Although his was molten steel.
It's pretty big, but I was working with scrap laying around at work. Keeping cost down. It works though and if I had to I could probably cycle a round with my foot. The goop is just a no run 20 min epoxy that had a good hold strength I don't recall the brand.
That is a beast of a handle! Good work.
Members who have read this thread in the last 1 days: 0
Posting Permissions
Bookmarks