I'd lay that mount up on a flat piece of glass and see if it is twisted or warped.
Hello,
Looking for some help with bedding a one piece Ken Farrel mount on a Stevens200. Model#starts with G.
If I install and tighten the back screws only, then I have a gap between the mount and the reciever on the ejection port side in the front. If I install and tighten the front only screws I get a gap on the ejection port side at the rear.
I'm not sure how to proceed from here. Are the screw holes off a little? Is this normal? Thanks in advance!
I'd lay that mount up on a flat piece of glass and see if it is twisted or warped.
Thanks for the reply!
I'm having a tough time telling on the glass I layed it on...
Maybe I should back up a little . The mount is marked for, and was ordered for a Savage 110 short action. Would that be correct? Or is there a difference? Thank you for your help.
Bookmarks