Good info Stangfish, I ended up using a small washer placed on the end of the pin just under the c clip. I noticed that I could squeeze the trigger bracket together with my fingers and it would take out the side slop on the trigger. I think I actually had to file the washer to get the correct thickness. I'll have to try your way and I'm sure that it would make the sear engagement more consistent.
I also agree that there is no need to bend over backwards to lighten the wire spring so light. You always want some tention there or the sear may not catch resulting in an accidental discharge.
Would like to add that I have an accu trigger that is LE series and when turned all the way down it was lower than 1 lb and fairly in consistent.
When I shimmed it up like I described above, it took out the side slop and brought the minimum pull back up to a consistent 1.5 lb pull.
Bookmarks