Had a couple of rounds that were over-pressure and I noticed my ejector was not functioning. When I removed the bolt, it appeared the ejector was broken. Got home and tried to remove the ejector. The top of the ejector was stuck a short distance from the bolt face. I removed the retaining pin, but the ejector did not come out as normal. I sprayed it with a penetrating lubricant and started tapping the end of the bolt on a solid piece of iron to try to remove the ejector. I can get it to the point that it protrudes about 1/16" from the bolt face, but have not been able to get it any further. I put it in the freezer for a couple of hours to see if that would help, but no change. Any ideas?